You can right-click on the curve to get more points. ![]() This way, we set a threshold point for the compressor to work on.Īfter selecting the threshold point, bring the curve down to set the amount of compression. You’ll see that normally the yellow shade below the curve is low (marked with a purple arrow), but whenever there are “ess’ sounds, it goes way up (marked with a grey arrow).īring down point A a little above where the shade normally is. The point (A) marked by the blue arrow determines where the compression starts in terms of volume, and the curve after A (highlighted in white) determines how much the audio signal is compressed. Adjusting the frequency in Maximum Step 4: Compressing The “ess” Causing SoundsĪfter doing all the above steps, go to the left side of the plugin. ![]() For the vocal I used in this tutorial, it is nearly 6k and above. There’s no single formula.ĭrag and adjust the yellow band in that region, as shown below. You’ll need to use your ears and adjust the settings accordingly. Working with spectrogram view on the Maximus pluginĮvery vocal is different, so you can’t use the same settings for all vocals. Then try to see where the frequency spectrum is peaking in that yellow region. It’s the round button on the left side of the “monitor” option. Step 3: Analyzing The VocalsĬlick on the “ spectrogram output” option. ![]() Multi-band controls on Maximusįor de-essing, we only need to work with the yellow band, representing the frequency range between 2,000 Hz and 9,700 Hz. On selecting the preset, you’ll see three bands (as shown below) – low (red), mid (yellow), and high (green), as shown in the picture below. What this does is that it turns off compression for the lows and high bands. After opening Maximus, go to presets and select “ De-esser narrow band.” Selecting a preset on Maximus
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |